All faders in alsamixer set to -0dB unless otherwise specified. The analog gain setting on the input is set to match close to -3dB in the Audacity VU meter, with exception for when clipping occurs in which case it's set slightly below the level where it starts clipping (not applicable for these particular tests but it happened a couple of times during other experiments).Īs a complete side note, the previous graphs with Lollypop turned out to not even be with a flat EQ. I'll see if I can wire up headphones as well next time I'm at work, I don't think I have enough adapters to do that at home.Ĭurrently this is connected through a 3.5mm to RCA cable (left channel from the phone) into an RCA to 6.3mm plug adapter (second channel on the audio interface). Load the Waves VU Meter on any or all tracks while recording to make sure your recording levels are not too hot, or insert it on your master buss and pin it to your screen for a precise visual reference of your mix’s overall levels. The Scarlett Solo 3rd Gen is specified at 60 kOhm in line input mode so that's a very small load to drive. Please post sufficient info on test method and settings for others to reproduce your results. It's not exactly unknown for DACs to misbehave with 0dB(FS) signals so that may be what's happening here. (10-02-2020, 08:45 AM)wibble Wrote: That's much more reasonable, and thanks for the effort.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |